| PASSIVE COMPONENTS |
 |
| ATTENUATOR |
|
| Bulkhead (female To female) Attenuator |
 |
Bulkhead Attenuator utilize a wavelength sensitive neutral density filters. Specify for 1310nm
and 1550nm operation. Available in SC, ST, FC for 5dB, 10dB, 15dB, 20dB, 25dB, 30dB
values. Other values available on request. |
|
| Variable Attenuator (Clip-On Type) |
 |
Variable attenuator (Clip-On type) is a completely passive device which works by physical
attenuation of a 3mm jacketed Singlemode cable. It can be attached at any point in a cable
providing attenuation levels from 0 to >47dB at 1550nm, 0 to >21dB at 1310nm and low back
reflection. Good for several uses. |
|
| In-line Fixed Attenuator |
 |
The In-Line Fixed Attenuator is built to meet your low reflection attenuation requirements.
Each cord is custom built upto 10 meters in length to accommodate your fiber length and
connector type. The 5dB and 10dB version hold a +/- 0.5dB tolerance with the 15dB and 20dB
holding a 1 dB tolerance. Please specify operating wavelength. |
|
| Variable Attenuator (Air-Gap Type) |
 |
| Air-Gap variable attenuator has an alignment sleeve that provides a low insertion loss of
0.15dB and can be used on both multimode and singlemode pplications. Attenuation range is
0dB to 20dB and is available in FC/PC type. |
|
| Plug Type (male To female) Attenuator |
|
Plug type attenuator contains doped fiber suitable for dual wavelength operation. Available in
FC, SC, ST, LC & MU for 5dB, 10dB, 15dB, 20dB values. Other values available on request. |
|
 |
|
| |
Connector
SC, FC
ST , Biconic
LC, MU |
Polish
UP APC
AP APC |
Fiber Type
SM Singlemode
MM Multimode |
Attenuation Level
03 - 3dB, 05 - 5dB
07 - 7dB, 10 -10dB
15 - 15dB, 20 - 20dB |
|
| |
| ^TOP |
 back to product page |
